- 2025-07-22
Aircraft washing water
Core pollution control objectives
Completely remove residual chloride/sulfate in the fuselage (concentration <5mg/L)
Eliminate magnesium and calcium scaling caused by hard water deposition (hardness ≤0.1dH)
High-precision reverse osmosis system configuration
Membrane separation unit
Seawater-grade composite membrane (desalination rate ≥99.8%)
Working pressure 5.5-7.0MPa (adaptive frequency conversion control)
Pretreatment module
Two-stage activated carbon adsorption (residual chlorine <0.01ppm)
20μm security filter intercepts particulate matter
Key performance parameters
Cleaning water quality assurance
Conductivity ≤10μS/cm (corresponding to TDS <5mg/L)
Silicon dioxide content <0.5ppm
System operation efficiency
Production Water volume 8-50m³/h (modular expansion design)
Chemical agent usage reduced by 40%
Aerospace exclusive design
Enhanced anti-corrosion performance
316L stainless steel pipe fittings (salt spray resistance > 2000h)
Epoxy coating of membrane shell (anti-corrosion grade C5-M)
Intelligent operation and maintenance system
Touch screen automatically records 120 sets of operating parameters
Early warning module monitors SDI value changes in real time
Implementation of benefit verification
Improved cleaning efficiency
Reduced water stains on the fuselage by 98%
Single cleaning cycle shortened by 35%
Full life cost optimization
Metal component corrosion rate reduced to 0.02mm/year
Membrane element service life > 5 years (flux attenuation < 8%)
Compliance certification
ISO 9001/14001 dual certification
Meets MIL-PRF-85772 military standard requirements
